Error codes dishwashers Abat

We have collected all the error codes of Abat dishwashers with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

Abat dishwashers errors, decoding

Error code	Description	Causes and solution
E01	Thermocouple X2 has broken.	The malfunction occurs due to oxidation of the thermocouple wires or the controller is out of order. Perhaps the controller just moved away and you need to reconnect it. Check controller connection to thermocouple X2. If necessary, clean the wires from oxidation or replace defective elements. You can do the work yourself or contact the service.
E02	Open thermocouple X3.	The problems are related to the controller (it is out of order and needs to be replaced). It is possible that the contacts on the thermocouple wire have oxidized. The connector is simply not connected to the controller. You need to check the wiring. Carefully remove the oxide layer with a knife. If the problem is with the controller, replace it with a new one. Restart the device and check.
E03	Problems with the water level sensor.	Possible causes of the malfunction: dirt has accumulated on the electrical wire, the installation was incorrectly installed initially, or the controller burned out / failed. It is necessary to clean the electrodes from dirt, check the correct installation, the integrity of the insulation. If necessary, replace defective parts.
E04	Problems with connecting phase and neutral wires.	The thermal protection +160 0C is triggered and the equipment stops working. The fuse has blown. Therefore, the sensor on the screen is triggered when the equipment is turned on. You need to check if the wires are connected correctly to X1. Replace burnt parts with new ones. If you can not do it yourself, contact the master.