We have collected all the error codes of De Dietrich dishwashers with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.
The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.
Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.
|Error code||Description||Causes and solution|
|d01||Water does not flow.||It is necessary to check the filling system: filling hose; valve; filter blockage. Also, the cause may be low water pressure.|
|d02||Drain problems.||Serviceability is accompanied by: 1. Clogged filter. 2. Impeller lock. 3. Clogged drain hose. 4. Breakage of the suction pump. Needs replacement.|
|d03||Water does not heat up.||To eliminate, you need to check the performance of the electric heater with a multimeter. If a malfunction is detected, the part needs to be replaced.|
|d04||The temperature sensor is defective.||The water temperature meter does not work. It is recommended to check the sensor contacts, as well as its serviceability. Replace the defective part with a new one.|
|d05||Pump problem.||The washing process does not start due to lack of water in the hopper or a faulty water level sensor. It is recommended to check the pump and level gauge.|
|d06||Pump problems.||Problems were found in the lower part of the pump, which is responsible for draining water from the bunker. It is necessary to check the serviceability of the pump and drain valve.|
|d07||Leak detected.||The problem occurs when water is detected in the sump. The drain system must be checked for leaks and the drain valve is working properly.|
|d08||Sprayer problem.||Water does not enter the hopper due to clogging of the pump impeller. Also, you need to make sure that the pressure of the central water supply is sufficient.|
|d11||Water level problem.||There is an underflow or overflow of liquid. It is recommended to check the serviceability of the water level sensor. If necessary, replace the meter with a new one.|
|d12||Leak in drain hose.||The problem is most often associated with leak detection in the drain hose. Check the tightness of the connections. The problem may be due to a faulty pressure switch.|
|d13||Overheat.||Fixed overheating of water in the bunker. The occurrence of a problem due to a failed temperature sensor. The meter needs to be checked and replaced with a new one.|
|d14||Wrong installation.||The problem occurs when: 1. Violation of the pipes for tightness. 2. Low pressure connected water supply. 3. Excessive clogging of the filter.|