We have collected all the error codes of Whirlpool refrigerators with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.
The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.
Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.
| Error code | Description | Causes and solution |
|---|---|---|
| AL 01 | The NTC sensor (negative temperature coefficient) in the refrigerator compartment is faulty. | Tighten the sensor and board contacts. Call a specialist to diagnose the elements. |
| AL 02 | Contact with air valve does not work. | A complete diagnosis of the motor and valves is required. The service technician will be able to identify the cause of the breakdown with special tools and eliminate them. |
| AL 03 | Freezer compartment NTC is out of order. | There may be a problem with the wiring of the unit. Complete diagnostics of temperature sensors and thermocouplers is recommended. Contact the service company. |
| CF | Communication between the electronic module and the control panel is broken. | The problem is serious and requires replacement of the interface module. Disconnect the device from the power supply, call a service worker. |
| The "-" sign is flashing | Inadmissible temperature for unit operation. | Take a temperature measurement. If it is ok, the sensor is faulty. If not, the problem is in the cooler. Contact the service company. |
| The number 15 (or lower numbers) is blinking | Unstable voltage in the network. | Power off and plug the device into a power outlet, check if it fits snugly. Measure voltage, inspect wiring. Buy a voltage regulator. |
| The light is blinking | Warming is observed in the refrigerating chamber. | The reason may be a poorly closed door, wear of the seal. Call the wizard to diagnose the temperature sensor. Perhaps a replacement is needed. |
| The interface does not work | Communication between the interface and the board is broken. | The service worker must inspect the board, ring the contacts. He will also replace faulty elements and make the necessary settings. |