We have collected all the error codes of Hoover washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.
The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.
Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.
|Error code||Indicators||Description||Causes and solution|
|E01||1||The hatch door is not closed.||Close the hatch tightly again, make sure that the lock and the locking mechanism are working.|
|E02||2||Water from the tank does not fill.||Check filler system, filter, pump, hose. Make sure the tap is open and there is good pressure in the water system.|
|E03||3||Waste water does not drain.||Inspect the drainage system for clogging. Check filter, drain pump, pump, hose.|
|E04||4||Defective water inlet valve.||Make sure it is working; if it breaks, replace it with a new one.|
|E05||5||Water is not heated.||Most likely the tubular electric heater is faulty. Check it and the temperature meter.|
|E06||6||Imbalance during washing or breakdown of the electronic unit.||Need diagnostics of the electronic unit. Before that, try again to distribute things in the drum and repeat the wash. Perhaps there are too many things and they need to be divided into several washings.|
|E07||7||Engine malfunction or jammed sunroof lock.||Check the engine and door lock of the loading shaft.|
|E08||8||The door lock is jammed. Possible engine damage.||Diagnose the engine, tachogenerator, hatch lock.|
|E09||9||Damage to the motor of the machine.||Need a diagnosis of the electric motor and its circuits.|
|E11||11||An open circuit between the electronic board and the electric drying heater.||Check the board and the heater, the circuit between them.|
|E12||12||The connection between the drying tubular heater and the electronic board has been lost due to an open circuit.||Ensure that the heater and the electronic circuit board are in good condition with the circuit between them.|
|E13||13||The electronic module has failed. The washing goes without heating.||Check temperature sensor and electric heater, control unit.|
|E14||14||The washing process is in cold water, without heating. Damage to the electronic module.||Diagnose the temperature meter, heater and control unit.|
|E15||15||The electronic module is defective.||Non-volatile memory of the control board malfunctioning.|
|E17||17||The tachogenerator sensor is out of order.||Replace the item.|
|E18||18||Failure of the electronic unit.||Install a working module.|