Error codes refrigerators BEKO

We have collected all the error codes of BEKO refrigerators with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

BEKO refrigerators errors, decoding

Error code	Description	Causes and solution
+2	The cooling system is out of order.	The reason is a refrigerant leak or a broken sensor contacts. Perform a visual inspection of the cooling circuit, call a specialist to eliminate the leak.
+3	The defrost system is defective.	The breakdown is provoked by burnout of sensors or violation of the integrity of the wiring. Call a service technician to repair broken components.
+4	The sensor is not giving a signal.	Contacts broken or circuit interrupted. In the event of a short circuit, the sensors burned out. View the contacts of the item that is not responding. Retighten them or replace the sensor.
+5	Short circuit of NTC of BEKO refrigerator.	Due to the violation of the protective shell of the thermistor, it does not work. Call the service wizard to diagnose the circuit and the state of the thermistor.
+6	Button fired.	Breakage is caused by key wear or heavy dirt. Clean the button panel, wipe with alcohol. If the problem persists, call the technician.
+7	The compressor has failed.	If the engine continues to run, filters are dirty, or freon has leaked. Visually inspect compressor, filter and capillary system. Check for refrigerant leaks.
+12	Switch failure.	There is no contact between the module and the sensor. In this situation, we recommend that you immediately call an employee of the service center to eliminate the breakdown.
E0	The FRZ sensor in the BEKO refrigerator is out of order.	Due to a breakdown, the compressor runs without stopping. Contact service for diagnostics and repair work.
E1	NTC (evaporator switch) does not work.	In the service center, specialists will diagnose non-working elements, check the contacts and ring the circuit from the sensor to the module.
E3	The air sensor thermistor is out of order.	All repair work with NTC sensors is carried out only in a service center. Disconnect the equipment from the power supply and call the master.
E4	Defrost tubular electric heater defective.	If this code is displayed on the screen, turn off the equipment succulently, take out the products if there is any and contact the service center.
E5	The air damper of the refrigerator compartment is defective.	It is impossible to eliminate the fault on your own. You need to contact the service and repair service for diagnostics and repair.
E6	The cooler on BEKO refrigerator models with the No-Frost system has failed.	The breakdown can be eliminated at the service center. Ask for the help of the wizard, before his arrival, disconnect and unload the device from the products.
E7	Internal sensors are not functioning.	The malfunction of the failed components is diagnosed in the service department. Call technicians to replace defective components.
E8	The solenoid internal sensor is defective.	We do not recommend replacing components on our own. Unplug the device from the mains, unload and call a repair technician.
E9	The solenoid spring sensor of the BEKO refrigerator has failed.	You can disconnect the device from the electricity and call the repair and service team to replace the sensors.