Error codes washing machine ASKO

We have collected all the error codes of ASKO washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

ASKO washing machine errors, decoding

Error code	Description	Causes and solution
E01	General error in the failure of the drive motor	Malfunction of one or more elements in the motor power circuit. Such as a triac, reverse relay, connectors, motor, tachogenerator.
E02	Does not flood water. This error occurs if the tank is not filled with water to the required level.	There may be a problem in the absence of water supply, malfunction of the inlet valve, electronic controller, water level sensor, blockage.
E03	Does not drain	Possible malfunctions: 1. Disconnected controller and drain pump. When the pump is turned on, the voltage at its contacts is applied by applying 220V to it. 2. Water level sensor. At the outlet, the sensor in the absence of water in the tank should produce a voltage less than 0.6 V. 3. The drain plug. It is necessary to check the entire path. 4. Electronic controller.
E04	Low water supply. It occurs in the event that for a certain time the tank was not filled with water to the desired level.	1. Low water pressure in the water supply system. 2. Clogged water supply path.
E05	Overheating water. The temperature of the water in the tank exceeds the set.	It is necessary to check the temperature sensor, heater.
E06	Does not heat water. For the temperature allotted for heating did not reach the set.	Check TEN and chains.
Door lock fault	The hatch door is open.	You need to close the door again to reset the error. If the error reappears, the locking mechanism, the electronic controller, is checked.
Floaming	Increased foaming.	Run the rinse program. If the problem occurs, try again using another detergent or reduce the dosage available.
Over flov	Overflowing water in the tank.	Check the water inlet valve for proper function. Also level sensor and controller.
Termistor fault	Temperature sensor out of order.	Check sensor for short or open connection.
Pressure sensor error	Water level sensor out of order.	Check the sensor and pipe connected to the tank.