Error codes washing machine BRANDT

We have collected all the error codes of BRANDT washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

BRANDT washing machine errors, decoding

Error code	Description	Causes and solution
D01	Do not flood the water. The problem is in the valve or control module.	Check the pressure level in the supply system, inlet valve, supply hose.
D02	The machine does not drain.	Check the drainage system for blockage or damage, hose, pump, filter.
D03	Not heated water. Open circuit. Control module failure	There may be a failure in the control module or an open circuit. Most likely the heating element is faulty. Diagnose for resistance. Replace in case of breakage.
D04	Triac control module out of order.	Need a diagnosis of the motor. It is possible to replace the triac, control module.
D05	Faulty temperature sensor.	The temperature sensor should be checked for serviceability, if necessary, install a new one.
D06	WM motor does not work.	Check the motor and its connections. Repair or replace it.
D07	The hatch door is not locked.	Close the door again tightly. If the breakdown remains, the reason is in the lock and it must be replaced with a new one.
D10	Water exceeded the maximum mark in the tank.	The electronic controller and pressure switch must be checked for proper operation. Replace in case of malfunction.
D17	Parking sensor failure, belt break.	Inspect the pulley responsible for maintaining the magnet for integrity.
D21	The control module has failed.	Check the wiring by turning the machine back on. In the event of a breakdown, replace the power module.
ER12	The loading door is open.	Re-close the hatch and restart the program.