We have collected all the error codes of Gorenje washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.
The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.
Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.
| Error code | Description | Causes and solution |
|---|---|---|
| F1 | The temperature sensor has failed. | Check sensor and heating element. |
| F2 | The boot shaft hatch is not closed. | Close the door again. Make sure that the manhole cover is closed tightly and that the lock is working. |
| F3 | For a certain time, the required water level did not accumulate. | Check the inlet valve, pressure in the water supply system, supply system. |
| F4 | The engine control system has failed. | Diagnose the control unit. Replace if there is a malfunction. |
| F5 | Lost communication between controller and inverter. | Check the operation of the circuit elements. |
| F6 | For a certain time, the water in the tank did not heat up to the desired temperature. | Check the heating element and temperature sensor for serviceability. In case of breakage, replace the element. |
| F7 | Problem with water drain. | Inspect the drain system, hose, filter, pump. Possible clogging of the system. |
| F8 | In spin mode, the drum rotates slowly. | Check drive relay. |
| F9 | Leak detected. | Inspect the washing machine for water leaking into the drip tray. |
| Error code | Description | Causes and solution |
|---|---|---|
| F1 | The temperature sensor has broken. | Diagnostics and sensor replacement. |
| F2 | Water does not enter the machine. | Perhaps a small pressure in the water supply system, the water supply valve is closed, the filter is clogged. |
| F4 | No heating water. | The heating element or temperature sensor has failed. |
| F5 | Waste water does not drain. | Clogged drain system or pump defective. |
| F31 | The tachogenerator is out of order. | Diagnostics of the tachogenerator is needed, if a new one breaks down. |
| F32 | Damage to the motor control circuit. | Diagnose the motor, circuit and its circuits. |
| F41 | Overheating of water in the tank. | Possible damage to the temperature meter or heating element. |
| F43 | The water in the tank heats up too quickly. | Check temperature sensor and heater. |
| F61 | The drum rotates slowly. | Diagnostics of the motor drive relay. |
| F62 | The motor control system is faulty. | Replace the item. |