Error codes washing machine HANSA

We have collected all the error codes of HANSA washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

HANSA washing machine errors, decoding

PC series

Error code Description
Е01 The sunroof is not locked. It is necessary to re-close the hatch tightly, to make sure that the lock and the locking mechanism are operational.
E02 No water enters the tank. Open the supply tap, check the pressure in the water supply system.
E03 Waste water does not merge for a certain time. Inspect the drain system, filter, hose for blockage. Make sure the drain pump is working.
E04 There is a water overflow in the machine during washing or filling the tank.
E05 For a certain time, the tank was not filled with water to the required level. Possible damage to the level sensor.
E06 The washing machine does not drain the water. Check the drainage system for obstruction, pump performance.
E07 Water leakage detected. Inspect the machine for leaks.
E08 Voltage failure. Make sure there are no power surges.
E09 High foaming. Reduce the dosage of detergent. Try using a different powder.
E10 High voltage in the power supply, higher than permissible. Make sure there is no excess voltage in the mains.
E11 The triac is out of order. Replace the item.
E12 There is a leakage of water in the pan. Check pallet.
E14 Controller malfunctioning. Need diagnostics and element replacement.
E15 Critical damage to the electronic controller. Install a new one.
E21 Drive motor is locked. Carry out engine diagnostics.
E22 The motor rotates without a command. Need motor diagnostics, control systems.
E31 The temperature sensor has closed. Replace with a new one.
E32 Broken temperature meter. Check the sensor; replace if broken.
E42 Lock the boot hatch. Check the operation of the locking system and lock.
E52 A non-volatile memory malfunctioned.

PA Series

Error code Description
E05 Broken temperature meter in the washer. Set work item.
E07 The tachogenerator broke. Check the element, its circuit.
E08 The tachogenerator does not transmit signals during the operation of the spin mode. Replace with a working one.
Place for your advertisement. Information about advertising on this site. To read