Error codes washing machine Candy

We have collected all the error codes of Candy washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

Candy washing machine errors, decoding

Activa Smart Series

Error code	Description	Causes and solution
E01	The sunroof is not locked.	The hatch lock has broken or something is preventing the tight closure. Resubmit. In case of malfunction, replace the locking mechanism.
E02	Water does not flow.	The tank does not fill to the required level for a certain time. The bay valve, electronic controller or pressure switch is out of order. Clogged water supply system.
E03	Waste water does not drain.	Check the drainage system and filter for clogging. The drain pump may be defective.
E04	Damage to the filler valve. The water level in the tank exceeds the maximum permissible.	Diagnose and replace the fill valve and electronic controller + control triac.
E05	Water does not heat up.	Check the temperature sensor (resistance of about 20 kOhm at room temperature), the heater and the electronic controller, the program selector motor for serviceability. If broken, replace the element.
E07	Increased engine rotation.	The problem is in the tachogenerator. Check its winding resistance. It should be approximately 42 ohms (for CEZET motors) and 156 ohms (for HOOVER).
E09	Engine failure. The drive shaft does not rotate.	Need diagnostics of the power supply and triac. Replace the defective item.

Aquamatic Series

The error is determined by the number of flashes of the lower left LED. A series of blinks occurs with an interval of 5 seconds.

Number of blinks	Description
Steady on	The control module has failed, program failure.
1	The loading shaft hatch is not blocked.
2	The machine continues to collect water after the allotted time to complete this task. Perhaps low pressure in the water supply system, clogging of the water supply system.
3	Wastewater did not merge. Possible clogging of the drain hose, filter.
4	Leak detected. Check feed valve, pressure switch.
5	The NTC temperature meter is out of order.
6	EEPROM memory failure. Need a control module diagnosis.
7	Engine drive blocked.
8	Defective motor tachogenerator.
9	The drive motor triac is out of order.
12	There is no communication between the control and display module. Check their connections.
14	The control module has failed. Check the module and its connections.