We have collected all the error codes of BEKO washing machine with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.
The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.
Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.
| Error code | Description | Causes and solution |
|---|---|---|
| H1 | The temperature sensor is out of order. | Measure the sensor resistance, it should be around 4700 ohms at room temperature. |
| H2 | TEN is defective. | Check the resistance of the plugs of the heater, it is about 20-30 Ohms. Replacement of TEN and the electronic controller is possible. |
| H3 | Continuous heating due to active heating elements | Measure the resistance of the temperature sensor plug J2, should be about 4700 ohms at room temperature. It is possible to replace the electronic board. |
| H4 | The closure of the triac water supply valve. | It is necessary to check the wires and connections. |
| H5 | Water does not drain. The problem is in the drain pump, pump, drain system. | Inspect the drain system and filters, pump and pump performance. |
| H6 | The motor triac failed. | Run diagnostics and install a new triac, module or motor. |
| H7 | Malfunction of the water level sensor. | Make sure the door is tightly closed. Check the water tap, sensor connections, electronic circuit board. In case of malfunction, replace the sensor, electronic module, drain valve. |