Error codes vacuum cleaner robots Kitfort

We have collected all the error codes of Kitfort vacuum cleaner robots with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error.

Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

Kitfort vacuum cleaner robots errors, decoding

Error code	Description	Causes and solution
E01	The signal about the failure of the left wheel.	Most likely, rotation is blocked due to contamination of the element with dirt, threads, hair. Clean it and make sure it works freely.
E02	The right wheel of the device does not rotate.	Inspect the wheel. Perhaps its rotation is difficult due to blockage. Wound threads, wool, hair, dirt.
E04	The height sensors of the device do not fix the position on the working surface.	One or all of the wheels are not on the floor, hung on a step or threshold. Manually carry the machine and place it on a flat surface.
E05	The lower position sensors of the device are out of order or do not respond.	Before conducting diagnostics, make sure that they do not transmit signals. Wipe the sensor windows with a dry cloth or rag.
E06	Collision sensors located in the protective bumper do not transmit signals.	It is necessary to clean the surface of the protective bumper from dust and dirt, perhaps this interferes with the correct operation of the elements.
E07	The left side sweeper is out of order or does not rotate.	Disconnect the element, clean it from dirt, wool, threads and collected debris which may impede the rotation of the brush.
E08	A signal was recorded about incorrect operation of the right side brush.	Most likely the problem is an ordinary blockage of the brush. Remove it, clean it from accumulated debris and hair wound around it.
E09	A signal that the machine is stuck or is obstructed.	It is required to lift it and move it to a flat area. After that, run to work. If it does not help, the problem is the health of the sensors.
E10	Charging is performed during active operation of the device.	Before installing the device on the charging platform, you must turn it off. Otherwise, recharging will not be carried out until the correction.
Dust bag icon	The flashing trash bin icon means it is full to a certain level.	To fix it, you need to disconnect the container, clean it of accumulated debris and dust, install it back and start working.